Let's hope that the drivers issues will be solved in the best way
#Behringer firepower fca610 driver Pc#
I will follow the 3D in silence and with the greatest interestīecause i have actually a PC that i could use But without a DAW such interfaces don't do much of anything. You can create whatever routing the DAW will permit inside the DAW computer.
I suppose they could do that in the firmware, but it's kind of pointless for 99.9999% of the users. steer the SPDIF inputs directly out the analog outs. There's no hardware routing matrix I'm aware of that would e.g. That's the purpose of these devices: they are specifically INTERFACES for a DAW. But they all go to/from the Firewire/USB bus. In SPDIF mode you gain an input and an output pair, in ADAT mode you gain 8 ins and 8 outs. The port numbering tells the whole story. The 1616 has additional protocols possible on these jacks, and ADAT in addition on the opticals. The SPDIF input (over optical or coax) acts like an additional analog input pair, and the SPDIF output acts like an additional analog output pair.
Gino, the only way you can use a Firewire or USB Audio I/F is with digital audio data coming over the Firewire or USB bus, and being converted to Analog audio, or conversely, Analog audio entering the interface and being converted to digital data that is passed over the Firewire or USB bus. I also noticed that it was unstable when i used the coax spdif input and plugged an older m-audio as AD converter to get 2 more inputs. It was not working properly from the beginning but i thought that was from the drivers or the usb-port of my laptop.Then i found the new drivers and firmware and your forum and i tried to solve it but now i don't know what to do except of asking for a repair or a replacement. Please tell me what to do or how it will be repaired or replaced." I closed everything and wait for more than 5 minutes and reconnect them. Today the usb connection is not possible at all, the light in the front panel is always red flashing and never turn into blue when I connect the usb cable and the pc cannot connect. I have changed the usb cable and done everything possible but after sometime went off again. I have load all the new drivers from Behringer site and still the same situation. Until now it didn’t worked properly, sometimes the usb connection lost and then when I restart and reconnect it was ok. I have big problem with the FCA1616 that I received on. Could anyone help me please! This is the note i send to the internet purchaser of my FCA1616.
0 kommentar(er)
